三维电极法处理苯酚废水影响因素研究

根据电解原理,采用自制三维电极反应器对苯酚废水进行处理。在pH值为3,反应时间为120min,电解电压为15V,极板间距为10cm,曝气强度为0.6m3/h反应条件下,苯酚和COD的最大去除率分别为89.1%和83.2%。表明三维电极法适用于处理浓度较高、且有毒性的废水,是快捷、经济、高效的废水处理方法。     

Fenton氧化法预处理垃圾渗滤液试验研究

采用Fenton氧化法处理长沙市黑糜峰垃圾填埋场垃圾渗滤液原液,考察了影响COD去除率的各种因素,包括初始pH值、FeSO4·7H2O投加量、双氧水投加量、反应时间及投加方式等,试验结果表明:在初始pH值为3、FeSO4·7H2O投加量为0.5%、双氧水投加量为18 mL/L、反应时间为100 min、投加方式为3次投加的条件下,可使垃圾渗滤液原液的COD去除率达40%左右,并提高了生化比,为后续生物处理改善了条件.     

高铁酸钾氧化去除弱碱性地下水中低浓度石油类污染物实验研究

研究一般地下水弱碱性水溶液中,高铁酸钾对低浓度石油烃类污染物的氧化去除率。采用0#柴油模拟石油类污染物试验水样,氧化反应在200mL烧杯中模拟完全混合状态完成。实验分析浓度分别为5.02mg/L、2.05mg/L、1.01mg/L和0.52mg/L 4个水样石油类污染物氧化去除率。实验研究显示,石油类污染浓度与高铁酸钾浓度分别按1∶1、1∶2和1∶3投加进行配比,最大氧化去除率97.51%,平均氧化去除率89.46%,氧化反应结束时间为25T。采用乙酸等效计算的导致溶液p H降低小分子有机酸累积量较小;在高铁酸钾过量条件下,石油类污染物氧化反应近似为一级反应。     

Experimental investigation into the oxidation reactivity, morphology and graphitization of soot particles from diesel/n-octanol mixtures

Aiming to investigate the impacts of n-octanol addition on the oxidation reactivity, morphology and graphitization of diesel exhaust particles, soot samples were collected from a four-cylinder turbocharged diesel engine fueled with D100（neat diesel fuel）, DO15（85% diesel and 15% n-octanol, V/V） and DO30（70% diesel and 30% n-octanol, V/V）. All tests were conducted at two engine speeds of 1370 and 2150 r/min under a fixed torque of 125 N ·m. The soot properties were characterized by thermogravimet...     

Degradation of bisphenol A by photo-fenton processes

The photo-Fenton reactions, which could yield hydroxyl radicals via the catalytic degradation of H₂O₂ by Fe(II), were focused as one of the abiotic degradation processes of bisphenol A (BPA) in surface waters. At pH 6, in the presence of H₂O₂ only, 32% of BPA was degraded after 120?min of irradiation. However, 97% of BPA was degraded in the presence of both H₂O₂ and Fe(II). Without light irradiation, no BPA degradation was observed even in the presence of Fe(II) and H₂O₂. These results show that photo-Fenton processes are effective in the natural attenuation of BPA in surface water. In addition, the presence of humic acids (HAs), which were of more aliphatic nature, resulted in enhancing BPA degradation via the photo-Fenton processes. Therefore, HAs can be one of the important factors in enhancing the degradation of BPA in surface water via the photo-Fenton processes.     

高锰酸钾-粉末活性炭工艺处理城市污水的实验研究

高锰酸钾-粉末活性炭工艺能有效去除微污染水源中的有机物、浊度、色度,该工艺具有操作简便、易控制、投资节省的特点。本文通过改变传统工艺中用聚合氯化铝做混凝剂的做法,选用硫酸铝做混凝剂,确定影响处理效果的因素,得出最佳实验条件。实验结果表明,（1）高锰酸钾-粉末活性炭工艺处理效果与试剂投加顺序有密切关系;（2）高锰酸钾-粉末活性炭处理工艺能显著改善水质,比单独使用粉末活性炭效果更好。     

臭氧-生物活性炭技术在微污染饮用水处理中的应用

通过研究国内外臭氧—生物活性炭工艺的发展现状和应用实践，指出了该项技术在应用中体现出的优越性，并提出了此项技术在应用中存在的问题，部分地介绍了提高此项技术应用水平的措施。研究表明，臭氧—生物活性炭工艺在处理微污染饮用水将会受到重视和广泛地推广应用，同时也对今后的研究方向提出了相应的观点。     

Integration of microbial reductive dehalogenation with persulfate activation and oxidation (Bio-RD-PAO) for complete attenuation of organohalides

•Bio-RD-PAO can effectively and extensively remove organohalides. •Bio-RD alone effectively dehalogenate the highly-halogenated organohalides. •PAO alone is efficient in degrading the lowly-halogenated organohalides. •The impacts of PAO on organohalide-respiring microbial communities remain elusive. •Bio-RD-PAO provides a promising solution for remediation of organohalide pollution. Due to the toxicity of bioaccumulative organohalides to human beings and ecosystems, a variety of biotic and abiotic remediation methods have been developed to remove organohalides from contaminated environments. Bioremediation employing organohalide-respiring bacteria (OHRB)-mediated microbial reductive dehalogenation (Bio-RD) represents a cost-effective and environmentally friendly approach to attenuate highly-halogenated organohalides, specifically organohalides in soil, sediment and other anoxic environments. Nonetheless, many factors severely restrict the implications of OHRB-based bioremediation, including incomplete dehalogenation, low abundance of OHRB and consequent low dechlorination activity. Recently, the development of in situ chemical oxidation (ISCO) based on sulfate radicals (SO₄^·−) via the persulfate activation and oxidation (PAO) process has attracted tremendous research interest for the remediation of lowly-halogenated organohalides due to its following advantages, e.g., complete attenuation, high reactivity and no selectivity to organohalides. Therefore, integration of OHRB-mediated Bio-RD and subsequent PAO (Bio-RD-PAO) may provide a promising solution to the remediation of organohalides. In this review, we first provide an overview of current progress in Bio-RD and PAO and compare their limitations and advantages. We then critically discuss the integration of Bio-RD and PAO (Bio-RD-PAO) for complete attenuation of organohalides and its prospects for future remediation applications. Overall, Bio-RD-PAO opens up opportunities for complete attenuation and consequent effective in situ remediation of persistent organohalide pollution.     

Product identification and toxicity change during oxidation of methotrexate by ferrate and permanganate in water

• Oxidation of methotrexate by high-valent metal-oxo species was first explored. • Fe(VI) presented a higher reactivity to MTX than Mn(VII) at pH 8.0. • Ketonization and cleavage of peptide bond were two initial reaction pathways. • Products of MTX were not genotoxic, neurotoxic, or endocrine-disrupting chemicals. • The less biodegradable products exhibited developmental and acute/chronic toxicity. Accompanying an annual increase in cancer incidence, the global use of anticancer drugs has remarkably increased with their worldwide environmental prevalence and ecological risks. In this study, the oxidation of methotrexate (MTX), a typical anticancer drug with ubiquitous occurrence and multi-endpoint toxicity, by ferrate(VI) (Fe(VI)) and permanganate (Mn(VII))) was investigated in water. Fe(VI) exhibited a higher reactivity with MTX (93.34 M⁻¹ s⁻¹) than Mn(VII) (3.01 M⁻¹ s⁻¹) at pH 8.0. The introduction of Cu(II) and Fe(III) at 1.0 mM improved the removal efficiency of 5.0 μM MTX by 100.0 μM Fe(VI) from 80% to 95% and 100% after 4 min, respectively. Seven oxidized products (OPs) were identified during oxidative treatments, while OP-191 and OP-205 were characterized as specific products for Fe(VI) oxidation. Initial ketonization of the L-glutamic acid moiety and cleavage of the peptide bond of MTX were proposed. Additionally, a multi-endpoint toxicity evaluation indicated no genotoxicity, neurotoxicity, or endocrine-disrupting effects of MTX and its OPs. Particularly, serious developmental toxicity in zebrafish larvae was observed in the treated MTX solutions. Based on the acute and chronic aquatic toxicity prediction, OP-190, OP-192, OP-206, and OP-208 were deemed toxic or very toxic compared to harmful MTX. Furthermore, the reduced biodegradability index from 0.15 (MTX) to −0.5 to −0.2 (OP-192, OP-206, and OP-468) indicated the formation of lower biodegradable OPs. Overall, this study suggests that Fe(VI) and Mn(VII) oxidation are promising treatments for remediating anticancer drug-contaminated water. However, the environmental risks associated with these treatments should be considered in the evaluation of water safety.     

Chromium transport, oxidation, and adsorption in manganese-coated sand

We examine how the processes of advection, dispersion, oxidation-reduction, and adsorption combine to affect the transport of chromium through columns packed with pyrolusite (beta-MnO2)-coated sand. We find that beta-MnO2 effectively oxidizes Cr(III) to Cr(VI) and that the extent of oxidation is sensitive to changes in pH, pore water velocity, and influent concentrations of Cr(III). Cr(III) oxidation rates, although initially high, decline well before the supply of beta-MnO2 is depleted, suggesting that a reaction product inhibits the conversion of Cr(III) to Cr(VI). Rate-limited reactions govern the weak adsorption of each chromium species, with Cr(III) adsorption varying directly with pH and Cr(VI) adsorption varying inversely with pH. The breakthrough data on chromium transport can be matched closely by calculations of a simple model that accounts for (1) advective-dispersive transport of Cr(III), Cr(VI), and dissolved oxygen, (2) first-order kinetics adsorption of the reduced and oxidized chromium species, and (3) nonlinear rate-limited oxidation of Cr(III) to Cr(VI). Our work supplements the limited database on the transport of redox-sensitive metals in porous media and provides a means for quantifying the coupled processes that contribute to this transport.